User's Manual

43
4.2 Firmware Restoration
Firmware Restoration is used on an ASUS Wireless Access Point
that failed during its rmware upgrading process. It uploads the
rmware that you specify. The process takes about three to four
minutes.
IMPORTANT! Launch the rescue mode on the access point before
using the Firmware Restoration utility.
NOTE: This feature is not supported on MAC OS.
To launch the rescue mode and use the Firmware Restoration
utility:
1. Unplug the wireless access point from the power source.
2. Hold the Reset button at the rear panel and simultaneously
replug the wireless access point into the power source. Release
the Reset button when the Power LED at the front panel ashes
slowly, which indicates that the wireless access point is in the
rescue mode.
3. Set a static IP on your computer and use the following to set up
your TCP/IP settings:
IP address: 192.168.1.x
Subnet mask: 255.255.255.0