User's Manual

14
3.1.2 System
The System page allows you to congure your wireless access
point settings.
To set up the System settings:
1. From the navigation panel, go to Settings > Administration >
System.
2. You can congure the following settings:
• Change access point login password: You can change the
password and login name for the wireless access point by
entering a new name and password.
• USB setting: You can Enable HDD Hibernation and change
USB mode.
• Time Zone: Select the time zone for your network.
• NTP Server: The wireless access point can access a NTP
(Network time Protocol) server in order to synchronize the
time.
• Network Monitoring: You can enable DNS Query to check
Resolve Hostname and Resolved IP Addresses, or enable
Ping, then check your Ping Target.
• Auto Logout: You can set the time of auto-logout.
• Enable WAN down browser redirect notice: This feature
allows the browser to display a warning page when the
access point is disconnected from Internet. When disabled,
the warning page will not appear.
• Enable Telnet: Click Ye s to enable Telnet services on the
network. Click No to disable Telnet.
• Authentication Method: You can select HTTP, HTTPS, or
both protocols to secure access point access.
• Enable Reboot Scheduler: When enabled, you can set the
Date to Reboot and Time of Day to Reboot.
• Enable Web Access from WAN: Select Ye s to allow devices
outside the network to access the wireless access point GUI
settings. Select No to prevent access.
• Enable Access Restrictions: Click Ye s if you want to specify
the IP addresses of devices that are allowed to access to the
wireless access point GUI settings from WAN/LAN.