User’s Manual

4
ご注意
イク
使用済みのーター、PC等の電子機器には、環境に悪影響を与る有害物質が含
てお通常のゴミて廃棄すとはません。ルによ使用済み製品に使
用されている金属部プラチック部品ンポネントは粉砕されしい製品に再使用され
ますまたその他のンポトや部品、質も正処理される有害質の拡
となりすることにがり
ASUSは各国の環境等を満たし、またル従事者の作業の安を図る
境保護に関する厳しい基準を設ますASUSのルに対する姿勢は、
して す。
REACH
Complying with the REACH (Registration, Evaluation, Authorisation, and Restriction of Chemicals)
regulatory framework, we published the chemical substances in our products at ASUS REACH
website at http://csr.asus.com/english/REACH.htm
Federal Communications Commission Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference; and
This device must accept any interference received including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with manufacturer’s
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit dierent from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
The use of shielded cables for connection of the monitor to the graphics card is required to assure
compliance with FCC regulations. Changes or modications to this unit not expressly approved by
the party responsible for compliance could void the user’s authority to operate this equipment.
ムバーについの警
警告: バーの交換は正行わない破裂の原因ーは製
造元が指定すの、たはそれに相当すものご使用い。ー廃
棄の際は、製造元の指示に従ださい。