User Guide

Chapter 2: Hardware setupChapter 2: Hardware setup

Chapter 2: Hardware setup

2-362-36

2-36

2.7.62.7.6

2.7.6

SCSI backplanesSCSI backplanes

SCSI backplanes

To uninstall a SCSI backplane:

1. Disconnect all cables connected

to the rear of the SCSI

backplane.

2. Carefully push the backplane

upward to remove it from the

chassis.

3. Repeat steps 1 to 2 to remove

the other backplanes.

2.7.52.7.5

2.7.5

Front panel LED and switch boardFront panel LED and switch board

Front panel LED and switch board

To uninstall the front panel and swtich board:

1. Disconnect all cables connected to the rear of the board.

2. Remove the three screws the secure the board to the chassis.

3. Carefully remove the board out of the chassis.

When removed, the LED and switch board appears as shown. The LEDs and

switches on the board correspond to the LEDs and buttons on the system

front panel.

Front sideFront side

Front side

Rear sideRear side

Rear side

Locator switch connectorLocator switch connector

Locator switch connector

Panel connectorPanel connector

Panel connector

Front USB connectorFront USB connector

Front USB connector