Installation Guide

RAID configuration and driver installationRAID configuration and driver installation

RAID configuration and driver installation

2525

6. After you have created the RAID 0 set, press any key to reboot the

system.

During POST, the FastTrak S150 TX4™ BIOS checks and displays the

disk array information.

7. Once the array is created, use the FDISK utility to format the array as

a single hard drive.

8. After you have formatted the arrayed drives, install an operating

system (OS). The OS will treat the RAID 0 array as a single drive unit.

During the OS installation, the system prompts you to install third-party

SCSI or RAID driver. Refer to section “2. RAID driver installation” for

details.