Installation Guide

RAID configuration and driver installationRAID configuration and driver installation

RAID configuration and driver installation

2323

1.61.6

1.6

FastBuild™ UtilityFastBuild™ Utility

FastBuild™ Utility

The FastBuild™ Utility allows you to create RAID 0, 1, and 0+1 set(s) from

SATA hard disk drives connected to the SATA connectors supported by the

Promise

PDC20319 RAID controller.

To enter the FastBuild™ Utility:

1. Turn on the system after installing all the SATA hard disk drives.

2. If this is the first time you restart the system with the new hard disk

drives installed and connected to the SATA connectors, the FastTrak

S150 TX4™ BIOS displays the following:

3. Press <Ctrl+F> to display the FastBuild™ Utility main menu.

4. To make sure that the SATA hard disk drives are properly installed,

press <2> to view the drive assignments. When finished, press <Esc>

to return to the main menu.