User Guide

Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-542-54
2-542-54
2-54
2.10.82.10.8
2.10.82.10.8
2.10.8
Power suppy modulesPower suppy modules
Power suppy modulesPower suppy modules
Power suppy modules
The user can choose from any of these three power supply configurations:
You MUST disconnect all power cable plugs from the motherboard and
other installed devices before removing the power supply modules.
The picture below shows the motherboard and device connectors where
the power plugs are connected. Refer to the Appendix at the end of this
document for the power supply specifications.
600 W single600 W single
600 W single600 W single
600 W single
power supplypower supply
power supplypower supply
power supply
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)
2 x 300 W dual2 x 300 W dual
2 x 300 W dual2 x 300 W dual
2 x 300 W dual
power supplypower supply
power supplypower supply
power supply
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)
3 x 300 W redundant3 x 300 W redundant
3 x 300 W redundant3 x 300 W redundant
3 x 300 W redundant
power supplypower supply
power supplypower supply
power supply
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)(110 V/220 V autoswitch)
(110 V/220 V autoswitch)
Refer to this section when removing or installing power supply modules to
the barebone system.
• If you are using a 600 W (2 x 300 W) dual power supply, make sure
to plug the two power cords.
• If you are using a 600 W (3 x 300 W) redundant power supply, make
sure to plug the three power cords.
55
55
5
44
44
4
33
33
3
11
11
1
22
22
2