User Guide

Chapter 2: Hardware setupChapter 2: Hardware setup

Chapter 2: Hardware setup

2-182-18

2-18

2.7 Hard disk drives

2.7.12.7.1

2.7.1

Installing a hot-swap SATA/SCSI HDDInstalling a hot-swap SATA/SCSI HDD

Installing a hot-swap SATA/SCSI HDD

If you purchased an AS8, AS4, or AA4 configured model, follow these

instructions to install a hot-swap SATA or SCSI hard disk drive (HDD).

1. Open the front bezel to access the hot-swap drive trays.

2. Release a drive tray by pushing

the spring lock to the right,

then pulling the tray lever

outward. The drive tray ejects

slightly after you pull out the

lever.

3. Firmly hold the tray lever and

pull the drive tray out of the

bay.

4. An empty drive tray requires a metal bracket for support. Use a

Phillips (cross) screwdriver to remove the bracket when you are ready

to install a hard disk in the drive tray.

Metal bracketMetal bracket

Metal bracket

Tray leverTray lever

Tray lever

Spring lockSpring lock

Spring lock