User's Manual

ASUS AP1600R-E2 (BA2/BI2)ASUS AP1600R-E2 (BA2/BI2)

ASUS AP1600R-E2 (BA2/BI2)

6-196-19

6-19

6.1.4.66.1.4.6

6.1.4.6

Rebuilding a RAID setRebuilding a RAID set

Rebuilding a RAID set

The utility displays the condition of the RAID set during the POST. When a

RAID set is degraded, you can use the utility to rebuild it.

To rebuild a RAID array:

1. Enter the Adaptec RAID Configuration Utility following the instructions

in the section “Creating a RAID 0 (Stripe).”

2. Select

Array Configuration Utility Array Configuration Utility

Array Configuration Utility from the initial menu, then

press <Enter>.

Check the physical connections of the SATA hard disk drives before you

rebuild a degraded RAID set. Check the system and motherboard user

guide for additional information.

3. From the main menu, highlight Manage Arrays, then press <Enter> to

display the installed RAID sets.

4. Highlight the degraded RAID set, then press <Enter> to display the

array properties. The

Array Status Array Status

Array Status shows DEGRADED.