User's Manual

ManualsBrandsAsus ManualsServers & WorkstationsAP1600R-E2(BA2)

101

102

103

104

105

106

107

108

109

110

6-36-3

6-3

ASUS AP1600R-E2 (BA2/BI2)ASUS AP1600R-E2 (BA2/BI2)

ASUS AP1600R-E2 (BA2/BI2)

6.1.36.1.3

6.1.3

Setting the RAID item in BIOSSetting the RAID item in BIOS

Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID

set(s). To do this:

1. Enter the BIOS Setup during POST.

2. Go to the

Advanced MenuAdvanced Menu

Advanced Menu, select

Onboard deviceOnboard device

Onboard device, then press

<Enter>.

3. Select the item

SATA ConfigurationSATA Configuration

SATA Configuration, then press <Enter> to display

the configuration options.

4. Select

RAID RAID

RAID from the

SATA Mode SATA Mode

SATA Mode options, then press <Enter>.

5. Save your changes, then exit the BIOS Setup.

Refer to the BIOS setup for details on configuring the BIOS.

6.1.46.1.4

6.1.4

RAID configuration utilityRAID configuration utility

RAID configuration utility

You can create a RAID set using the utility embedded in the RAID

controller. For example, you can use the

Adaptec RAID ConfigurationAdaptec RAID Configuration

Adaptec RAID Configuration

Utility Utility

Utility if you installed SATA hard disk drives on the SATA connectors

supported by the Intel

6300ESB Southbridge.

The Adaptec RAID Configuration Utility allows you to create RAID 0 and

RAID 1 set using the SATA hard disk drives connected to the SATA

connectors supported by the motherboard Southbridge chip.

To enter the Adaptec RAID Configuration Utility:

1. Turn on the system after installing all the SATA hard disk drives.

2. During POST, the Adaptec HostRAID™ technology automatically

detects the installed SATA hard disk drives and displays any existing

RAID set(s). Press <Ctrl> <A> to enter the utility.