User Guide

Chapter 2: Hardware setup 2-10
2.6 Installing a hard disk drive
The server/workstation system
supports one IDE/Serial ATA hard
disk drive through a detachable hard
disk drive cage.
Hard disk drive cage
Configure your hard disk drive as Master/Slave device before installing
it to the chassis. Refer to the HDD documentation on how to set the
drive as a Master/Slave device.
2.6.1 Qualified hard disk drives
The table below lists the hard disk drives tested and qualified for use with
this server/workstation.
Table 2: Qualified hard disk drive vendors list
Vender Model Interface Speed Capacity
Seagate ST380021A IDE 7200rpm 80GB
Seagate ST3120023A IDE 7200rpm 120GB
IBM/Hitachi Deskstart IC35L090AVV207 IDE 7200rpm 80GB
Maxtor MAXTOR/6Y80L0 IDE 7200rpm 80GB
IBM/Hitachi Deskstart IC35L120AVV207 IDE 7200rpm 120GB
Maxtor MAXTOR/6Y160L0 IDE 7200rpm 160GB
Seagate ST3160023A IDE 7200rpm 160GB
IBM/Hitachi Deskstart IC35L180AVV207 IDE 7200rpm 180GB
Seagate ST380013AS SATA 7200rpm 80GB
Seagate ST3120026AS SATA 7200rpm 120GB
Seagate ST3160023AS SATA 7200rpm 160GB
Maxtor 6Y080M0 SATA 7200rpm 80GB
Maxtor 6Y120M0 SATA 7200rpm 120GB
You may purchase a second
hard disk drive cage to install
an additional HDD. Refer to
the next chapter for details.