User manual

WL-AM604g 11g WiFi ADSL Router User Manual
21
LINKAP ACT
xDSL LAN
4 3 2 1
!
3. Set the
WPA2 Preauthentication
to
Enabled
if you want to use this function.
4. By default, the
Network Re-auth Interval
is 36000 seconds. Set up this value
based on your network environment.
5. To set up RADIUS server information, key in the
WPA Group Rekey Interval
,
RADIUS server IP address
,
RADIUS port
, and
RADIUS Key
.
6. Set up the WPA encryption methods. If there are only WPA2 clients within your
network, select AES, if WPA clients only, select TKIP. If both exist, select TKIP+AES.
7. You can also enable WEP client to access your wireless network. To enable WEP
clients, set
WEP Encryption
to
Enabled
. Select 64-bit or 128-bit
Encryption
Strength
for key length then click
Set Encryptioin Keys
button to set up the keys.
Refer to
Open
mode Step 4 for key conguration.
8. Press
Save/Apply
to save and activate the settings.
WPA-PSK/WPA2-PSK
1. Click
Wireless -> Security
in the navigation menu to open the conguration page.
2. Select
WPA-PSK/WPA2-PSK
in the
Network Authentication
eld.
3. Key in the WPA Pre-Shared Key. The key is masked by the system. To check the
key, press
Save/Apply
and wait until the page refreshes. Then click
Click here to
display
link, you can see the key displayed in a separate window.
4. Set up the
WPA Group Rekey Interval
.
5. Set up the WPA encryption methods. If there are only WPA2 clients within your
network, select AES, if WPA clients only, select TKIP. If both exist, select TKIP+AES.
6. You can also enable WEP client to access your wireless network. To enable WEP
clients, set
WEP Encryption
to
Enabled
. Select 64-bit or 128-bit
Encryption
Strength
for key length then click
Set Encryption Keys
button to set up the keys.
Refer to
Open
mode Step 4 for key conguration.
7. Press
Save/Apply
to save and activate the settings.