User Guide

AMD-RAIDXpert2 User Guide
53987 Rev. 3.01 June 2016
52
Software Installation
Chapter 5
Note: The string should look like the following: splash -- break=mount nomodeset
10. When the BusyBox shell displays, perform the following steps:
a. Insert the USB flash drive.
b. Type the following, pressing Enter after each one:
 mount -t vfat /dev/sdal /tmp
Note: /dev/sda1 may need to be changed to /dev/sdb1 or /dev/sdc1, depending on the number of
devices there are.
 cp -ap /tmp/dd /
 /dd/pre_install
 umount /tmp
 exit
c. Remove the USB flash drive.
11. When the Welcome screen displays, select the desired language then click Continue.
12. Accept the defaults, then click Continue.
13. Accept the default settings, then click Continue.
14. Select Erase Disk and install Ubuntu, then click Install Now.
15. From the Write Changes to Disks? window, then click Continue.
16. Select the desired time zone, then click Continue.
17. Select the desired keyboard layout, then click Continue.
18. Enter valid entries for the following, then click Continue.
a. Your name
b. Computer name
c. User name
d. Password
e. Confirm Password
19. When the Installation Complete window displays, do the following:
a. Insert the USB flash drive.
b. Press CTRL + ALT + F1.
c. At the Ubuntu dialog box, enter ubuntu as the username, then press Enter.
d. When prompted to enter a password, leave it blank, then press Enter.
e. Type the following, pressing Enter after each one:
 sudo mount -t vfat /dev/sdal /mnt
 sudo cp -ap /mnt/dd /
 sudo /dd/post_install
20. Wait for the Setup is Complete message, then press CTRL + ALT + F7.
21. Click Restart Now to finish the installation.
22. When prompted, remove the CD/DVD and USB flash drive from the system, then press Enter.