Installation guide

ASUSTOR NAS Quick Installation Guide
o 2.5-inch hard disks and SSD hard disks: Place the hard disk into the area of the disk
tray outlined in red (see picture below). Make sure that the mounting holes on the bottom
of the hard disk and disk tray are lined up. Secure the drive with four screws.
• Slide the disk tray onto the rails of the disk bay. Using the latch, gently push the disk tray all the
way into the disk bay. Secure the disk tray in place by pushing down on the latch. The latch
should close easily and snap in with an audible ‘click’. Please make sure that the disk tray is
pushed all the way into the disk bay before attempting to secure the latch.
• Once the latch is secure, you can lock it in place using the disk tray lock. Using a flathead
screwdriver, turn the lock counterclockwise to lock the latch mechanism. Turning the lock
clockwise will unlock it.
Note: Disk tray locks can be found on AS51 series devices.
Page 9 of 23