User’s Manual
Table Of Contents
- 本マニュアルについて
- Chapter 1: ハードウェアのセットアップ
- Chapter 2: ノートパソコンを使用する
- Chapter 3: Windows® 10環境で使用する
- Chapter 4: Power-On Self-Test(POST)
- Chapter 5: FAQとヒント
- Chapter 6: 付録
- 光学ドライブ情報
- 内蔵モデムの適応規格 (規格/プロトコルなど原文掲載)
- Network Compatibility Declaration
- Non-Voice Equipment
- Federal Communications Commission Interference Statement
- Slave Equipment
- RF Exposure Warning
- CE Mark Warning
- Wireless Operation Channel for Different Domains
- France Restricted Wireless Frequency Bands
- UL Safety Notices
- Power Safety Requirement
- TV Notices
- REACH
- Macrovision Corporation Product Notice
- Nordic Lithium Cautions (for lithium-ion batteries)
- Optical Drive Safety Information
- CDRH Regulations
- CTR 21 Approval (for Notebook PC with built-in Modem)
- ENERGY STAR complied product
- 電気・電子機器に含有される化学物質の表示について 
- 回収とリサイクルについて
- 筐体のコーティングについて
- 日本国内での無線周波数帯のご利用について
- 聴覚障害を防ぐため
90
ノートパソコン ユーザーマニュアル
• Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING! Any changes or modications not expressly approved by
the grantee of this device could void the user’s authority to operate the
equipment.
This device operates within a 5.15-5.25 GHz frequency range and is
restricted for indoor use only. Outdoor operation within 5150-5250 MHz is
prohibited.
This equipment complies with FCC RF exposure limits set forth for an
uncontrolled environment. The equipment must not be co-located or
operating in conjunction with any other antenna or transmitter.
Slave Equipment
This device is a slave equipment. This device is not radar detection and not
ad-hoc operation in the DFS band.
RF Exposure Warning
This equipment must be installed and operated in accordance with
provided instructions and the antenna(s) used for this transmitter must be
installed to provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with any other
antenna or transmitter. End users and installers must be provided with
antenna installation instructions and transmitter operating conditions for
satisfying RF exposure compliance.