User manual

1-30
Chapter 1: Product Introduction
Chapter 1
13. Chassis intrusion connector (4-1 pin CHASSIS)
Thisconnectorisforachassis-mountedintrusiondetectionsensororswitch.Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusionsensororswitchsendsahigh-levelsignaltothisconnectorwhenachassis
componentisremovedorreplaced.Thesignalisthengeneratedasachassisintrusion
event.
Bydefault,thepinlabeled“ChassisSignal”and“Ground”areshortedwithajumper
cap.RemovethejumpercapsandenabletherelatedoptionsinBIOSifyouintendto
use the chassis intrusion detection feature.
Amessageappearswhenyouconnectthesensororswitchatthersttimeorwhenyou
reconnectthesensororswitchtothisconnector.Resetthesystemtoexitthemessage.
14. Serial port connector (10-1 pin COM)
Theseconnectorsarefortheserial(COM)port.Connecttheserialportmodulecable
tooneoftheseconnectors,theninstallthemoduletoaslotopeningatthebackofthe
system chassis.