User manual

SMART Self Test [On]
S.M.A.R.T. (Self‑Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power‑on Self Test) when an error occurs in the
hard disks. Conguration options: [On] [Off]
SATA6G_1~6(Gray) [Enabled]
Allow you to enable/disable the SATA6G_1~6 port. Conguration options: [Disabled]
[Enabled]
Hot Plug [Disabled]
These items allow you to enable/disable SATA Hot Plug Support. Conguration options:
[Disabled] [Enabled]
External SATA [Disabled]
Allow you to enable/disable the external SATA support. Conguration options: [Disabled]
[Enabled]
Spin Up Device [Disabled]
Allow you to enable/disable the spin up device feature. Conguration options: [Disabled]
[Enabled]
SATA Device Type [Hard Disk Drive]
Allow you to identify the installed SATA device type. Conguration options: [Hard Disk Drive]
[Solid State Drive]
Typology [Unknown]
This item allows you to identify the SATA topology. Conguration options: [Unknown] [M2]
[Direct Connect] [ISATA] [Flex]
Device Sleep [Disabled]
This item allows you to enable or disable device sleep. Conguration options: [Disabled]
[Enabled]
SATA DEVSLEP Idle Timeout Cong [Disabled]
This item allows you to enable or disable SATA DTIO Conguration. Conguration options:
[Disabled] [Enabled]
2.6.6 USB Conguration
The items in this menu allow you to change the USB‑related features.
The USB Devices item shows the auto‑detected values. If no USB device is detected, the
item shows None.
Legacy USB Support [Enabled]
[Enabled] Your system supports the USB devices in legacy operating systems.
[Disabled] Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
2‑32 Chapter 2: BIOS information