User Guide

6-18
Adaptec 7800 Family Manager
[xxxxx09D] Unexpected interrupt
The Adaptec driver received an interrupt from the system that does
not correspond to any adapter supported by the driver. This could
be caused by another host adapter from a different vendor, such as a
video card or a network card. The problem can also be caused by
malfunctioning hardware.
[xxxxx0a3] Adapter diagnostic failure - possible resource conflict
The driver failed the internal software or hardware diagnostic. Refer
to your host adapter’s user’s guide for troubleshooting information.
[xxxxx0ca] Cannot initialize device
The system, host adapter, or target device is busy or is not
responding. The target device could not be initialized.
[xxxxx0cb] Unable to allocate memory. Decrease alad_instr_buffersz in space.c
The driver has requested a larger buffer size than the available
RAM. Either increase the amount of RAM in the system, or decrease
the user option alad_instr_buffersz in the
/etc/conf/pack.d/alad/space.c file.
[xxxxx0cc] CONFLICT: Disconnection must be enabled in order for tag-queueing to
work
Use the SCSISelect utility of your host adapter to enable
Disconnection for each device reporting this message. Alternatively,
disable tagged queuing in
/etc/conf/pack.d/alad/space.c file by
setting alad_do_tagged = 0. If tagged queuing is disabled,
performance may be negatively affected.
❒