User Guide

6-9
SCO UNIX Installation
5
Modify the mscsi file according to your hardware setup:
– If you are booting from a 7800 Family host adapter, make
sure the host adapter prefix for the host adapter number 0 is
alad .
– If you are not booting from a 7800 Family host adapter,
make sure the host adapter prefix for the host adapter
number 0 is the appropriate prefix for each device on your
primary Adaptec host adapter. See the table below:
6
Save the file and exit the text editor.
Rebuild the UNIX Kernel
To rebuild the UNIX kernel with the new changes, follow these
steps:
1
Type the following at the # prompt and press Enter after each
line:
cd /etc/conf/cf.d
./link_unix
Status messages appear.
2
When the kernel has been built, shut down the system by
typing haltsys and pressing Enter.
3
Tu rn
OFF
the system power when you are prompted to do so.
The UNIX kernel has been prepared for 7800 Family host adapter
operation.
Host Adapter
Prefix Type of Driver
Primary Adaptec
Host Adapter
ad
eiad
spad
arad
smad
alad
blad
embedded
embedded
embedded
BTLD
BTLD
BTLD
BTLD
AHA-1540/1640 family
AHA-1740 family
AIC-6260 family
AIC-7770 family
AIC-6260/6360 family
AIC-78xx, AIC-7895
AIC-789x