User Guide

6-4
Adaptec 7800 Family Manager
8
Type alad or blad and press Enter. The alad driver for your
7800 Family host adapter has been relinked to the SCO UNIX
kernel.
Installation is complete!
Installing SCO OpenServer 5
1
Insert the SCO OpenServer 5 Boot floppy diskette into the
primary floppy drive and turn
ON
the computer.
2
When you see these prompts
SCO OpenServer (TM) Release 5
Boot
:
type link and press Enter.
3
Type alad325 or blad325, or type ahslink for OpenServer 5.00,
as the package you want linked to the system and press Enter.
4
Insert the requested volume (i.e., the 7800 Family Manager Set
diskette for SCO UNIX) in the floppy drive and press Enter. If
your driver is already embedded, several messages appear
including a message similar to
Table “io_init” contains (at 21) another routine named
“aladinit.”
Please enter
Which (0-40) to replace (‘?’ to list),
‘a’ to add “aladinit” at the end [default]/
‘n’ to do nothing
or ‘q’ to quit:
5
If the above message does not appear, skip to step 6.
Otherwise, enter the corresponding number for “aladinit or
bladinit.” In the above example, the number 21 appears in the
Table “io_init” contains (at 21) another routine named “aladinit”
message, and is the number that should be entered. If you are
unsure of which number to use, enter a “?” to list possible
values; use the number that is listed next to “aladinit.’ In
general, enter 21 for OpenServer 5.0.0 and 5.0.2, and enter 25
for 5.0.4.