User Guide

6-2
Adaptec 7800 Family Manager
Installing the Driver When Installing SCO UNIX
To install the alad / alad325 or blad / blad325 drivers at the same time
you install SCO UNIX, follow the instructions below for the version
of SCO UNIX you are installing.
Installing SCO UNIX 3.2 v4.2, SCO ODT 3.0, or
SCO OpenServer 3.0
Follow these instructions only if you are installing SCO UNIX
3.2v4.2, SCO ODT 3.0, or SCO OpenServer 3.0 for the first time. The
instructions for installing the driver are the same for these SCO
products.
Note:
Remember that UNIX commands are case sensitive.
Enter the commands exactly as shown in the instructions.
1
Insert the SCO UNIX N1 (Boot) floppy diskette into the
primary floppy drive and turn
ON
the computer.
2
When you see these prompts
SCO UNIX System V/386
Boot
:
type link and press Enter.
Note:
Do not use the link command to install the driver
for SCO OpenServer 5. See Installing SCO OpenServer 5
on page 6-4.
3
Type alad or blad as the package you want linked to the system
and press Enter.