User Guide

6-1
6
▼ ▼ ▼ ▼
SCO UNIX Installation
This chapter explains how to install the Adaptec 7800 Family
Manager Set Driver
alad
or
alad325
(for Ultra SCSI), and
blad
or
blad325
(Ultra2 SCSI) for SCO UNIX—SCO UNIX 3.2v4.2, SCO
OpenDesktop 3.0 (ODT 3.0), SCO OpenServer 3.0, and SCO
OpenServer 5.
The
alad
and
blad
drivers (or packages) are used with SCO UNIX
3.2v4.2 based products (SCO UNIX 3.2v4.2, SCO ODT 3.0, or SCO
OpenServer 3.0). The
alad325
and
blad325
drivers (or packages) are
used with SCO OpenServer 5. The
alad
and
alad325
drivers support
Ultra SCSI and earlier Adaptec 7800 host adapters, the
blad
and
blad325
drivers support Ultra2 Adaptec 7800 host adapters. Refer to
the Adaptec 7800 Family host adapters on page 1-3.
If you are performing a first time SCO UNIX installation, see
Installing the Driver When Installing SCO UNIX
on page 6-2 to begin
driver installation. If SCO UNIX is already installed in your system,
see
Installing the Driver When SCO UNIX is Already Installed
on
page 6-5.
Note:
If you are installing SCO UNIX products with a SCSI
tape drive, set the tape drive to SCSI ID 2; if you are
installing with a CD-ROM, set the CD-ROM drive to SCSI
ID 5 as recommended by SCO.