User Guide

2-4
Adaptec 7800 Family Manager
Completing a Fresh Windows NT 4.0 Installation
1
Start your system with the Windows NT Boot Diskette in the
floppy drive.
2
When prompted, insert diskette #2 in your floppy drive. After
a few moments you will see a blue screen. To setup Windows
NT now, press Enter.
3
Press S to skip auto-detection of your SCSI host adapter.
4
Press S again to specify an additional device.
5
Press Enter to select Others; insert the 7800 Family Manager
Set diskette for Windows NT in your floppy drive.
6
Select from the following drivers:
Adaptec AHA-290x/291x/294x/394x/4944/AIC-78xx PCI SCSI
Controller (NT 4.0)
or
Adaptec AHA-294xu2/AIC-7890/91 PCI Ultra2 SCSI Controller
(NT 4.0)
7
Highlight a driver and press Enter.
8
To add other host adapters that are not part of the 7800 Family,
press S and repeat from Step 4 for each additional adapter and
insert the appropriate driver disk. The Adaptec 7800 Family
host adapters use the same driver; it is not necessary to install
the driver again.
9
Press Enter to continue with the Windows NT operating
system setup. Follow the instructions onscreen and in the
Windows NT documentation to complete the installation.