User's Manual

To set up the System settings:

1. From the navigation panel, go to Advanced Settings >

Administration > System tab.

2. You can conﬁgure the following settings:

• Change the router login password: You can change the

password and login name for the wireless router by entering

a new name and password.

• WPS button behavior: The physical WPS button on the

wireless router can be used to activate WPS.

• Time Zone: Select the time zone for your network.

• NTP Server: The wireless router can access a NTP (Network

time Protocol) server in order to synchronize the time.

• Auto Logout: System will auto log out the administration

page after an idle period. To disable Auto logout, set the

value in 0.

• Enable WAN down browser redirect notice: When WAN

connection is down, the system will pop up a screen to guide

to how to conﬁgure the WAN connection. If you don’t like to

see this notice, select No to disable the notice.

• Enable Reboot Scheduler: Click Yes to reboot the wireless

router on a regular schedule.

• Enable Telnet: Click Yes to enable Telnet services on the

network. Click No to disable Telnet.

• Enable SSH: Click Yes to enable SSH access for the LAN or

WAN. Click No to disable SSH access.

• Idle Timeout: Conﬁgures the idle-timeout period for Telnet/

SSH.

• Authentication Method: You can select HTTP, HTTPS, or

both protocols to secure router access.

• Enable Web Access from WAN: Select Yes to allow devices

outside the network to access the wireless router GUI

settings. Select No to prevent access.

• Allow only speciﬁed IP address: Click Yes if you want to

specify the IP addresses of devices that are allowed access to

the wireless router GUI settings from WAN.

3. Click Apply.