Users Manual

6
D
C
B
A
E
F
G
H
E
A
B
C
D
F
5
4
3
21
10
11 12
1 2
3
4
5
6
DRAWN BY
Cokiey
DRAWING DATE
07/05/2019
UNLESS OTHERWISE SPECIFIED:
DIMENSIONS ARE IN MILLIMETERS
SURFACE FINISH:
TOLERANCES:
LINEAR: +/- 0.1mm
ANGULAR: +/- 0.5 Deg
SCALE : 1:1
SIZE:
FCC Card / FCC卡
Qty:1000
工艺：
深圳市亿莱顿科技有限公司
SHENZHEN ELECTRON TECHNOLOGY CO., LTD
PO NO.：
G
H
10
11 12
Warning!
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme à Industrie Canada exempts de licence standard RSS (s).
Le fonctionnement est soumis aux deux conditions suivantes:
(1) ce dispositif ne peut pas provoquer d'interférences et
(2) cet appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais
fonctionnement de l'appareil.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment. (Example - use only shielded interface cables
when connecting to computer or peripheral devices).
Radiation Exposure Statement:
The equipment complies with FCC Radiation exposure limits set forth for uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and
your body.
Shielded USB cable must be used to comply with the FCC Class B limit.
FCC Statement
A4纸张大小