User's Guide

101, Boul. Roland-Therrien Bureau 500,
Longueuil, QC J4H 4B9, Canada
Tel.[phone], Fax [phone]
www.astus.com
Astus QC25 - Hardware user Guide 11 / 13
The information contained in this document is confidential
and proprietary to Astus Inc. Any distribution or
reproduction without prior authorization is prohibited.
Pattern Description
OFF The QC25 has
Flash red 4x / 4 sec SIM card not detected.
Flash red 2x / 4 sec No cell carrier detected
Flash red 1x / 4 sec Cell carrier detected, no data connection
Flash green 1x / 8 sec Not in route, not connected
Flash green 1x / 4 sec Try to connect
Flash green 2x / 4 sec Connected to the Astus remote server
Flash green 3x / 4 sec Same as above + GPS position is valid
Flash green 4x / 4 sec Same as above + CAN bus connection established
After 5 minutes of operation, the LED will automatically turn OFF. To re-enable the LED,
disconnect the QC25 from the vehicle’s OBD2 port or from the harness, then re-connect.
6 Regulatory Information
6.1 FCC
6.1.1 Compliance Statement - Part 15.19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
Warning - Part 15.21
Any changes or modifications to this equipment not expressly approved by Astus Inc. may cause harmful
interference and void the user's authority to operate this equipment.
FCC Interference Statement - Part 15.105.b
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television