User manual

QS-2W
7
WHAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
 Remote control sends a Stop message.
 Hood is open.
 Brakes are applied.
 Engine is over-revving.
 Main switch is OFF.
M
AIN SWITCH
Main switch is usually mounted under dashboard. It is a toggle
ON/OFF switch that is used to cancel start functions.
It does not disable other commands which remain active.
STOP
When engine is running on a remote start, you can turn it off by pressing and buttons
simultaneously.
Confirmation Lights - Horn - Sound - Display A
Vibration
2
LOW TEMPERATURE MODE
In Low Temperature (Sentinel) mode, system starts your engine automatically when temperature falls
below a preset level.
Engine will run for programmed runtime, after which system will wait 2½ hours and then start engine again
if temperature is still below preset level.
To activate/cancel Low Temperature mode, press
and buttons simultaneously.
When mode is activated:
Parking lights will flash 4 times, then, if temperature is below preset level, engine will start.
If temperature is above preset level, system waits until it goes below preset level before starting engine. If
system cannot execute command (for example, hood is open), confirmation will be different (lights: 3).
When mode is cancelled:
Parking lights will flash twice to confirm that mode is cancelled. Applying brakes also cancels Low
Temperature mode.
Confirmation See TABLE OF COMMANDS on page 4.