User manual
QS-2W
6
UPON ENTERING YOUR VEHICLE...
Do not apply brakes; this will stop engine immediately.
Insert ignition key and turn it to ON position.
DO NOT TURN IGNITION KEY TO
START POSITION.
Drive as usual.
STATUS
When this command is sent, command module checks engine status (running or not) and lock status, then
retransmits this information to remote control which indicates the results on the LCD display with a
combination of pictograms.
Pictograms
and
indicate lock status and pictogram
, if it appears on the display, indicates that
engine is running.
Pictograms representing the parking lights indicate that command has been received.
When remote control receives a confirmation, it flashes the relevant pictograms and vibrates twice.
If vehicle is out of range, display flashes all pictograms and remote control beeps to indicate that
command could not be received by either the control module or the remote transmitter.
E
NGINE RUNTIME
Your engine will stop automatically after a preset time (see SETTING RUNTIME on page 8). Parking lights
will stay on as long as engine is running.
T
RIGGER INPUT
Your remote starter is equipped with a negative trigger (pulse) input.
This input can be connected to another remote control device or to a timer
output (optional).
If this input is connected, consult this device's manual or ask your technician
which command controls Start/Stop function.
Start/Stop commands received on this input are ignored while engine is running
on a remote start.
Confirmation Lights 1 Horn - Sound - Display -
Vibration
-
CONTINUOUS MODE
Continuous Mode function lets you remove key from ignition while leaving engine running. This convenient
feature allows you to leave vehicle for short periods of time while climate controls remain on.
To access Continuous Mode, send Start command while engine is idling (see STARTING THE ENGINE on
page 5).
Parking lights, engine and preset accessories will remain on for the duration of the programmed runtime
(see SETTING RUNTIME on page 8).
Remove key, exit vehicle and lock doors. All safety devices will remain active.
If you return to your vehicle before runtime has elapsed, just turn key to ON position and depress brake
pedal.
Confirmation Lights 1 Horn - Sound Melody Display AB
Vibration
2