User manual

QS-2W
5
CONFIRMATIONS
Sent by vehicle
Confirmations sent by the vehicle are generated as soon as command is received by starter module. Your
remote starter will always confirm that the command has been received, either by sounding the horn or by
flashing the parking lights.
Parking light confirmation is mandatory while horn confirmation is optional (programmable) and requires an
additional connection and equipment during installation.
Sent by remote control
Display flashes three times then stays on for 15 seconds, after which remote control switches to sleep
mode.
The signals that generate these confirmations come from the vehicle and are sent only once after remote
control has sent a command.
Confirmations sent by the remote control may be neutralized by radio or electromagnetic interference from
nearby electronic devices. If you do not receive any confirmation in a given place, move away from
electronic devices then press Status command; starter module will indicate lock status and if engine is
running.
START COMMANDS
STARTING THE ENGINE
To start engine, press button.
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once
(duration: four seconds) then stay on all the time engine is running.
If more than one command is sent, each successive start command resets runtime to the beginning,
parking lights flash once to confirm command has been received and horn sounds once to let you know
engine is already running.
Confirmation Lights 1 Horn - Sound Melody Display AB
Vibration
2
In this case, remote control confirmations indicate that command has been received but not if the start
sequence was successful or not. To check if engine has started, see Status command on next page.
If main switch is in OFF position, key is in Ignition position or hood is open, the start will be interrupted and
confirmations will be different.
Confirmation Lights 1 Horn - Sound 3 (high) Display -
Vibration
2
IF ENGINE DOES NOT START
If your system cannot start engine at first attempt, it will wait a few seconds then try again; it could try again
twice depending on reason for failure to start.
After three attempts, it will shut down automatically and wait for a new command. In this case,
confirmations sent by the vehicle are the same, but remote control does not send any confirmations.