User manual

QS-2W
4
TABLE OF COMMANDS
CONFIRMATIONS
VEHICLE REMOTE CONTROL
COMMANDS BUTTONS
H
ORN LIGHTS SOUND DISPLAY VIBRATION
MELODY
AB
2 START /
C
ONTINUOUS MODE
1y 1
3 (HIGH)
-
2 
STOP - 1 - A 2
LOCK
1 ♥
1 1 C -
UNLOCK
- 2 2
D
-
TRUNK
- 3 1 (
HIGH) E -
ACTIVATE / CANCEL
L
OW TEMPERATURE MODE
- 4/2/3 w - - 1
ACTIVATE / CANCEL
U
TILITY
- 1 - - 1
RUNTIME
- 1 - 4 -
-
1
CAR FINDER
7 3 - - 1
STATUS
- - -
2
OUT OF RANGE 1 ABCDE -
y. THIS CONFIRMATION IS SENT ONLY IF START COMMAND IS REPEATED
WHEN ENGINE IS ALREADY RUNNING
.
w.
4 = ACTIVATE / 2 = CANCEL / 3 = SYSTEM NOT READY
♥. T
HIS CONFIRMATION IS SENT ONLY IF LOCK COMMAND IS REPEATED
(
PROGRAMMED AS "ACTIVATED" DURING INSTALLATION).
S
CREEN SHOWS A COMBINATION OF SEGMENTS RELATED TO ENGINE STATUS (RUNNING OR NOT)
AND/OR LOCK STATUS. SEGMENT RELATED TO TRUNK RELEASE IS NEVER SHOWN WITH THIS
COMMAND
.

I
F MAIN SWITCH IS IN OFF POSITION, HOOD IS OPEN OR KEY IS IN IGNITION POSITION, START CYCLE
IS INTERRUPTED AND CONFIRMATIONS ARE AS INDICATED IN SHADED AREA
.
N
O CONFIRMATION IS SENT IF START FAILS AFTER START CYCLE OR IF ENGINE STALLS. START
CONFIRMATION CAN TAKE UP TO
5 SECONDS BEFORE BEING SENT IF ENGINE IS ALREADY RUNNING.