User manual

QS-2W
3
THE REMOTE CONTROL
Your remote control has been designed to fit the natural contours of your hand so that it is easier to use. It
works off one regular AAA battery.
Up to three additional remote controls can be assigned to your vehicle. See your dealer for replacement
batteries or additional remote controls.
NOTE: The range of your remote control can be affected by a weak battery, interference from nearby metal
structures, hydro poles, or crowded parking lots.
USING YOUR REMOTE CONTROL
To send a command, press for two
seconds on the appropriate button.
Command may not be sent if the
button is not pressed long enough.
Even if the button is pressed for
more than two seconds, only one
command is sent.
Remote control beeps once (low
beep) at the beginning of the
transmission then beeps again
(high beep) at the end of the transmission, i.e. about 2 seconds after the button was pressed.
Immediately after a command is sent, remote control switches to receive mode for 5 seconds while waiting
for a confirmation signal.
Remote control sends audible (piezo), visual (LCD display) and physical (vibration) confirmations which
are described later in this guide. After issuing the confirmation signals, remote control switches to sleep
mode to reduce battery consumption.
Note: Communication between the vehicle and remote control only takes place in one direction at a time,
therefore it is better to wait for a command to be confirmed before sending another command, otherwise
the vehicle and remote control could transmit at the same time which would block the command sent and
the confirmation signal received.
Remote control shown could differ from that included in the kits.
REPLACING THE BATTERY
We strongly recommend keeping a replacement battery in your glove compartment.
Remote control needs one AAA battery.
To replace the battery, slide the latch sideways and remove battery cover on the back of the remote control
case, remove old battery and replace it with a new one.
Make sure the battery is the right way round; see pictogram inside the cover.
Start
Lock
Status
Unlock
Antenna
Piezo
LCD display