Installation manual

17
Programming Tables
In the following tables, the shaded option is the default setting.
DEFAULT SETTING:
Normal operation
AUTOMATIC TACH LEARNING
CANNOT BE PROGRAMMED UNTIL INSTALLATION IS COMPLETE
Note: Vehicle engine has to be warmed up before doing any programming.
Place DIP switches as illustrated,
start the vehicle using the key, and then press on the brakes.
The tach learning function takes a little over 4 seconds.
After this delay, the unit will come out of tach learning mode.
When tach signal is detected, LED will flash the same number of times as the number of cylinders selected.
If tach learn mode fails, the control module programs actual settings for DIP switches 8 & 9
(idle speed) and the cylinder setting will remain the same as it was before programming started
(see LEVEL 2 programming).
An installer can therefore change the parameters of Dipswitches 8 & 9 without worrying about the number of
cylinders previously programmed.
The technician would simply have to put Dipswitches 1, 5, 6 & 7 to automatic tach learning mode,
without starting the vehicle.
This way, tach learning mode will fail, which will maintain the original cylinder setting but allow you to
program the new idle speed.
Default settings:
1 cylinder; 800 RPM
IN MOST CASES, IT IS RECOMMENDED TO USE
THE AUTOMATIC TACH LEARNING OPTION AS
LONG AS ENGINE HAS BEEN PREVIOUSLY
WARMED UP.
TRANSMITTER CODE LEARNING
STAGE 1 - LEVEL 1 5 6 7 8 9
Initiate STAGE 2 of programming

   
Initial Programming Reset
    
Transmitter Learning
    
Normal Operation
    
TACH AND CYLINDERS
STAGE 1 - LEVEL 2 5 6 7 8 9
1 Cylinder
  
2 Cylinders
  
3-4 Cylinders
  
5-6 Cylinders
  
8 Cylinders
  
10 Cylinders
  
12 Cylinders
  
Automatic Tach Learning
  
Hybrid Engine (See P2-10 p.11)
 
800 RPM
 
600 RPM
 
500 RPM
 