User manual

<>34;"%
6
START COMMANDS
STARTING THE ENGINE
To start the engine, press button (horn: 0, lights: 1).
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once (duration: four
seconds) then stay on all the time engine is running.
If more than one command is emitted, each successive start command resets runtime to the beginning, parking
lights flash once to confirm command has been received and horn sounds once to let you know engine is already
running.
Repeating this command will produce an audible confirmation that engine has started, which can be useful if
vehicle is not in sight.
I
F ENGINE FAILS TO START
If your system cannot start your engine at first attempt, it will wait for a few seconds and then try again (it could try
again twice depending on reason for failure to start).
After three attempts, it will shut down automatically and wait for new command (see “Start fail Codes“ on page 18).
U
PON ENTERING YOUR VEHICLE
...
 Do not apply brakes; this will stop engine immediately.
 Insert ignition key and turn it to “ON” position.
DO NOT TURN IGNITION KEY TO
“START”
POSITION.
 Within 20 seconds, execute Antitheft disarm sequence (if applicable).
 See “Antitheft” on page 15.
 Drive as usual.
E
NGINE RUNTIME
Your engine will stop automatically after a preset time.
Parking lights will stay on as long as engine is running.
Engine runtime is programmable.
W
HAT STOPS THE ENGINE
For your safety, engine will not start or will stop if:
 Remote control sends a stop message.
 Hood is open.
 Brakes are applied.
 Gearshift is not in “P” or “N”.
 Engine is over-revving.
 Main switch is OFF.