Installation Guide

Using your Power Drill, drill a hole in that spot.
Using the Driver Bit, install the anchor into the hole.
Fasten the fabric on that side.
Pull the fabric snug across the opening and mark the clip position on the other side.
Do not over-tighten fabric.
Drill holes and install hardware on other side.
Attach fabric.
4. REMOVE FABRIC AND LABEL
Once the fabric has been properly installed, remove each piece and label the
opening with a permanent marker, using the numbers from your house drawing.
STORAGE AND CLEANUP
AstroGuard can be folded and stored in storage bags. Always make sure the fabric is
clean and dry before storage. You can clean AstroGuard with water and a mild soap,
such as dishwashing liquid. For persistent stains, use OxiClean and a scrub brush.
If any chipping of the stucco occurred during installation, simply fill the hole with
stucco patch, let dry and touch up with paint. You can also paint the AstroGuard
hardware after it is installed so it blends nicely with your home.
Thank you for purchasing AstroGuard.
For more information go to: www.homedepot.com and search “Astroguard”
Or call [phone]