Install guide

DRINKING WATER SYSTEM
ASTROBOY Countertop Smart RO System
TDS meter
T.D.S
DRINKING WATER SYSTEM
ASTROBOY Countertop Smart RO System
ABSTRO OY
AB
STRO OY
1 Switch off water source
and electricity.
2 Turn off system power
switch
4 Remove water tank and holder.
5 Take out the 4 fixed screws. Then
remove filters and connectors.
6 Coil the connectors with Teflon
tape and connect to a new filter.
Then connect to its tube.
7 Put back the tube joint to the tank
cap. switch on water source and
electricity.
3 Take out tube joint.
Check carefully to see if there is a leaking. If so, repeat the procedures described above.
Deliver-valve
Water supply connector
Components & Selections
¨Selections
¨Components
Faucet Smart cap
Transformer
8mm over-flow tube white x 1
6mm feed water tube white x 1
6mm drain out tube orange x 1
Tubes
Change filters and membrane
To ASTROBOY
Withe Teflon tape