Instruction manual

ManualsBrandsASTRO ManualsComputer equipmentWM-3014

WM-3004-HD HD LCD WAVEFORM MONITOR INSTRUCTION MANUAL

Front panel parts and their functions

Number Part Description of function

<1> Power switch/LED

This switch is used to turn the power ON and OFF. (Its LED

lights up green while the power is supplied.)

<2> LOCK switch/LED

This switch is used to lock the panel switches and save the

setting values simultaneously.

Wait appears at the

bottom right of the screen while the settings are being saved,

and upon completion of the saving process, PANEL LOCK

appears. Do not turn off the power while the setting saving

process is in progress.

The saved settings are loaded when the power is turned on.

(The LED of this switch lights up yellow while the panel

switches are locked.)

<3> Mode switch

This switch is used to select the monitor's mode. The mode is

selected in the following sequence:

PICTURE1 PICTURE2 PICTURE3 WAVEFORM

MENU 1 2 AUDIO STATUS VECTOR

<4> Adjustment dial This dial is used to adjust and select the settings.

<5> Setting switch This switch is used to adjust and select the settings.

<6> Headphone jack The sound is output from this jack (diameter: 35 mm).

<7> Liquid crystal display The images appear on this display.

<8> TALLY 1

Tally lamp (red): this is controlled by the rear panel tally

connector (contact supply type).

<9> TALLY 2

Tally lamp (green): this is controlled by the rear panel tally

connector (contact supply type).

<10>

1/4-20UNC threaded

hole

Threaded hole for a screw to anchor the monitor (used to

anchor the monitor to a tripod, arm, etc.).

<11> INPUT switch

This switch is used to select SDI A or SDI B for the input

signals. When it is held down (for more than one second),

analog signals are input.

<12> DISPLAY switch

This switch is used to set whether the information is to be

partially displayed on the screen or not displayed at all. When

it is held down (for more than one second), the top and bottom

of the screen are inverted.

<13> OVERLAY switch

This switch is used to change the picture overlay settings.

When it is held down (for more than one second), the color

setting screen appears. (The color setting items differ

according to the mode selected.)

<14> FREEZE switch

This switch is used to select freeze or update.

Freeze is released by switching the input signals or format.

Bear in mind that if the input signals are cut off or their format

has been changed in the freeze status, the correct data will not

be output.

<15> FUNC switch

This switch is used to select the function switches (switches F1

to F5).

<16> F1 switch