Instruction manual

WM-3004-HD HD LCD WAVEFORM MONITOR INSTRUCTION MANUAL
38
[Description of operations]
Switch Description of function
FUNC switch
This switches the display to the VECTOR mode setting screen.
(Refer to section 3.3.5.2)
When the gain setting is
fixed Fix x1
(Not used)
When the gain setting
can be varied Val x*.**
Use the dial to set the magnification
rate of the gain. (Variable range: 0.03
to 7.97)
Adjustment dial
When line select is ON Use the dial to increment or decrement
the lines.
When the gain setting is
fixed Fix x1
(Not used)
When the gain setting
can be varied Val x*.**
The gain is an integral value after the
decimal places have been rounded
down (with a figure or 4 or below) or
rounded up (with a figure of 5 or
above). (All values below 1.00 are set
to 1.00; similarly, all values above 7.00
are set to 7.00.)
If the gain magnification rate is an
integer, it is increased in 1.00
increments, and when 7.00 is reached,
it is returned to 1.00.)
Setting switch
When line select is ON Use the switch to select the field.
(This applies with 1H or 2H only; field
switching applies only with interlacing
or segmented frame format.)
F1 switch
GAIN Fix x1/Val x*.**
Press this switch to set line select to OFF and switch between the
fixed (Fix x1) and variable (x*.**) gain setting.
In the fixed (Fix x1) status, the loci between the pixels are
interpolated for the display; in the variable status, only the points are
displayed.
F2 switch (Not used)
F3 switch (Not used)
F4 switch (Not used)
F5 switch
LineSelect
Press this to set line select to ON or OFF. When line select is ON,
the gain setting is fixed (Fix x1).