Instruction manual

WM-3004-HD HD LCD WAVEFORM MONITOR INSTRUCTION MANUAL
14
[Description of screen displays]
Item Description Display modes
Input
Displayed here is the input channel (SDI A, SDI B or
Analog) which has been selected by the INPUT switch.
P1・P2・W・V・S・
A・M
Format
The selected format is displayed here.
Indicated within the parentheses on the line below are
the input signal format and field (or frame) frequency.
When analog input has been selected even if 1035
input signals are supplied, these signals will be
identified as 1080 signals. If no signals are input
(when
NoSignal appears on the screen), "*" appears.
(For details on the formats, refer to Chapter 4.)
If the format which has been set and the format of the
actual input signals differ,
Format appears in red.
P1・P2・W・V・S・
A・M
(Reference)
The input reference signal is displayed here. Int
denotes an internal sync signal; Ref denotes an
external sync signal.
P1・P2・W・V・S・
A・M
NoSignal
If the signal which has been set and the actual input
signals differ,
NoSignal appears in red.
P1・P2・P3・W・V・
S・A・M
VITC
The time code (VITC) is displayed here.
P1・P2・P3・W・V・
S・A・M
YCRCE
This is where the Y signal is checked for CRC errors
and the number of errors is displayed. The CRC
errors are counted even in the freeze status.
When an error is found, YCRCE appears in red for
one second.
Note: The CRC errors are not counted when analog
signals are input. Neither are they counted for one
second after the input signals have been changed by
the INPUT switch.
P1・P2・W・V・S・
A・M
PCRCE
This is where the Pb and Pr signals are checked for
CRC errors and the number of errors is displayed.
The CRC errors are counted even in the freeze status.
When an error is found, PCRCE appears in red for
one second.
Note: The CRC errors are not counted when analog
signals are input. Neither are they counted for one
second after the input signals have been changed by
the INPUT switch.
P1・P2・W・V・S・
A・M
LAST
The time elapsed since the last error was found is
displayed here.
P1・P2・W・V・S・
A・M
TIME
The time elapsing after the WM-3004 was started or
error count was reset is displayed here.
P1・P2・W・V・S・
A・M
Freeze
This indicates the freeze status. When the freeze
status is established, Freeze appears in blue.
P1・P2・P3・W・V・
S・A・M
Filter
This indicates whether the video filter is ON or OFF.
P1・P2
Mono
This indicates whether monochrome is ON or OFF.
P1・P2
FRC
This indicates whether the 8-bit processing using the
frame rate control is ON or OFF.
P1・P2
Abbreviations used in display mode column:
P1･･･PICTURE1, P2･･･PICTURE2, P3･･･PICTURE3, W･･･WAVEFORM, V･･･VECTOR, S･･･STATUS,
A･･･AUDIO, M･･･MENU