Instruction manual

15
4.2.1 Switches Common to All Modes (Fixed-function Switches)
• The functions of the following switches are common to all modes.
• Note that some switches are not available depending on the mode.
Switch Name
Number Marked in
Front View
Description of Function
MODE  Turns on/off the menu of modes to select from.
FREEZE  Switches between the FREEZE and UPDATE options of input pictures.
LINE SEL  Turns on/off the menu of lines to select from.
OVERLAY  Turns on/off the picture overlay function.
FUNCTION  Turns on/off the menu of functions to select from.
 MODE: Shows a menu of modes to select from.
The texts PICTURE, WAVEFORM, VECTOR, STATUS and MENU appear on the
screen next to the F1, F2, F3, F4 and F5 switches, respectively. Pressing the F1 to F5
switches in this order with these texts on screen moves through the picture mode,
waveform mode, vectorscope mode, status mode, and menu mode. This switch can be
used in any of the operation modes.
 FREEZE: Switches between the FREEZE and UPDATE options of input pictures.
The text FREEZE is shown in reverse video at the top of the LCD display as long as the
input picture is kept frozen. Input video data at that point is retained. This switch can be
used in any of the operation modes.
Note: Do not change the input video format or input channel during freeze, as this may cause the
monitor to malfunction.
 LINE SEL: Enables you to select a line to monitor.
This switch can only be used in the waveform and vectorscope modes. The numbers of
the selected line and field appear in the upper-right corner of the screen.
For HDTV signal input, the numbers read as shown below:
For SDTV signal input, the numbers read as shown below:
If you turn on the picture overlay function when the LINE SEL switch is on, the position of the
selected line is indicated on the overlay picture.
 OVERLAY: Outputs the input picture onto the background. This switch cannot be used in the
picture mode.
If you set the OVERLAY CONT option of the menu mode to NORMAL (default), a pre-adjusted
input picture is output onto the background.
If you set the OVERLAY CONT option of the menu mode to DIM, the overlay picture of a mode

∗
: ←Field number (where, ∗ denotes 1 or 2)
0423 ←Line number
(0986) ←Total sum of lines (visible only when F2 is shown)

∗
: ←Field number (where, ∗ denotes 1 or 2)
0251 ←Field line number
(0254) ←Total sum of lines