Instruction manual

11
 POWER Switches between the power-on and stand-by states.
 3/8" threaded hole Screw hole for anchoring the monitor onto a tripod, arm, etc.
2.2 WM-3001’s Rear View and Components
WM-3001’s Rear View
Rear-panel Components and Their Functions
Number Component Description of Function
 SDI IN Input terminal for HDTV SDI and SDTV SDI signals
 SDI MONITOR OUT Output terminal for simplified monitoring of input signals
 ANALOG Y
Input terminal for the Y signal of HDTV analog input. For HDTV analog input,
synchronization is achieved by means of the Y signal.
 ANALOG Pb Input terminal for the Pb signal of HDTV analog input
 ANALOG Pr Input terminal for the Pr signal of HDTV analog input
 POWER Turns on/off the power.
 Power supply connector Four-pin, round male camera connector for 12 V input (GND: pin 1; 12 V: pin 4).
 TALLY connector (*4)
Four-pin, round female camera connector (TALLY 1 (red): pins 1 and 4; TALLY 2
(green): pins 2 and 3).
 Termination selector switch Switches between the terminating resistors of YPbPr signal input.
*4 Power supply and TALLY connectors







IN
INPUT
MONI T OR OUT
Y
P
B
PR
SDI
ANAL OG
POWER DC I N( 1 2 V)
TALLY
ANA.
DI GI.
YP
B
P
R
HDT V
Y
P
B
PR
HI GH
75Ħ
MODEL :
SER NO:XXXXXXXXX
MADE I N JAPAN