Instruction manual

2.3.3 Control method - VG-849 or 859 series generator

To control the VD-1673 using a VG-849 or 859 series generator, proceed with the connections and

control in the sequences given below.

 Connections

1. Using the HDMI cable, connect the HDMI output port of the VG-849 or 859 series

generator to the input 1 port of the VD-1673.

2. Turn on the power of the VD-1673.

3. Turn on the power of the VG-849 or 859 series generator.

 Control

When the VG-849 or 859 series generator is operated in the sequence shown below, the

“HDMI Switcher Setting” control screen appears on the display.

FUNC → 3 → SET → TIMING → SHIFT → B or C (* Press the

number which will result in displaying “HDMI Switcher Setting” on the bottom level of the front

panel display.)

Timing Edit: B (0 - B)

HDMI Switcher Setting

Fig. VG-849/859 series generator front panel display 1: Timing data selection

→ SET

Mode: Selection (0/1)

In: 1 (1/2) Out: 1 (1-8)

Fig. VG-849/859 series generator front panel display 2: HDMI Switcher Setting

* The VG-849 or 859 series generator will not recognize the VD-1673 unless the

connections are performed in the sequence described above.

* When exercising control over the VD-1673 using a VG series generator, connect the

generator to the input 1 port of the VD-1673. (The switcher cannot be controlled in

this way if the generator is connected to the input 2 port.)

CAUTION