Instruction manual

Chapter 2 CONTROL METHODS (CONTROL MODES)
11
 Control
When the VG-870 series generator is operated in the sequence shown below, the “VD-1673
(HDMI SWITCHER)” control screen appears on the display.
MENU → select “Program Edit” → SET → select “OUTPUT” → SET
→ select “Digital OUTPUT” → SET → select “HDMI” → SET → select “VD-1673”
→ SET
Fig. VG-870 series generator front panel display 1: VD-1673 setting
For each of the generator’s output ports, the following settings are available.
Table Control method using VG-870 series generator
Setting item Description Setting Description
0 SELECTION mode *2 Mode Output mode selection
1 DISTRIBUTION mode *2
1 Input port 1 In Input port selection
2 Input port 2
1 Output port 1
2 Output port 2
3 Output port 3
4 Output port 4
5 Output port 5
6 Output port 6
7 Output port 7
Out *1 Output port selection
8 Output port 8
CAUTION
*1 When “SELECTION mode” has been set as the output mode, the TMDS, DDC and
CEC signals are all switched; when “DISTRIBUTION mode” has been set as the
output mode, only the DDC and CEC signals are switched.
*2 For further details on the SELECTION mode and DISTRIBUTION mode, refer to
“3.1 Output modes” (on page 15).