Instruction manual

Chapter 1 CONCERNING THE VD-1673
3
 CONFIGURATION switches
The CONFIGURATION switches have the functions described below.
Table CONFIGURATION switches
Name of function Switch no. Description
1 2 Used to set the control mode.
* Refer to “Chapter 2 Control Methods (Control
Modes)” (on page 7).
(OFF) (OFF) Control is exercised using the “front panel switches.”
(ON) (OFF) Control is exercised using the “EXT I/F connector.”
CONTROL
(OFF) (ON) Control is exercised using a “VG series generator.”
3 Used to set the output mode when “front panel switch”
control has been selected as the control mode.
* Refer to “3.1 Output modes” (on page 15).
(OFF) The switcher operates in the switching mode.
OUTPUT
(ON) The switcher operates in the distribution mode.
4 5 Used to set the pre-emphasis level of the TMDS
signals.
* Refer to “3.4 Pre-emphasis level” (on page 16).
(OFF) (OFF) 0 dB
(ON) (OFF) 3 dB
PRE-PMPHASIS
(OFF) (ON) 6 dB
6 7 8
Set all of these three switches to OFF.
Reserve
OFF OFF OFF
1.3.2 Rear panel
(7) (8) (9)
A C IN (100-240V)T 3. 15A
EXT I /F IN1 IN2 OUT1 OUT2 OUT3 OUT4 OUT5 OUT6 OUT7 OUT8
Fig. Rear panel
Table Names of the parts and what they are used for
No. Name of part Description of setting
7 EXT I/F connector Used to control the VD-1673 by inputting signals to this connector when “EXT I/F
connector” control has been selected as the control mode.
8 INPUT These are the HDMI input ports of the VD-1673.
9 OUTPUT These are the HDMI output ports of the VD-1673.