Troubleshooting guide

SECTION 4
MAINTENANCE
53
3. Carefully slide the Service Station out of the Service
Station port. NOTE: Do not pull Service Station all the
way out until you disconnect the Ribbon Cable.
NOTE: Place an absorbent towel under the Service
Station before you remove it to catch any drips or leaks.
4. Disconnect the Ribbon Cable. Slide the Latch open on
the Service Station Circuit Board to release the Ribbon
Cable. Remove the Service Station.
Remove the Ink Tanks
1. Open the Front Cover (hinged at bottom).
Unlatch the three Locks [A] and pull the
Ink Tank(s) out of the Printer.
2. Carefully package the Ink Tanks in the
original packaging.
IMPORTANT: Make sure the ink seals
on the Ink Tanks are facing up to prevent
leakage.
3. Pack the Ink Tank bays with absorbent towels to catch any ink drips or spills.