Troubleshooting guide

SECTION 4
MAINTENANCE
47
Replacing the Ink Waste Tray
The Ink Waste Tray soaks up any excess ink that may drip from the Print Engine during operation. After a
period of time it may become saturated and need replacement.
1. Open Ink Tank Door.
2. Push in on the Tabs to release the Ink
Waste Tray and remove it from unit.
3. Replace with a new Ink Waste Tray.
Replacing the Sheet Separators
The Sheet Separators insure separation of the pieces as they are
being fed. If you experience double sheet feeding and cannot
adjust the Separators to prevent it, replace the Separators.
Replacing the Sheet Separators is not difficult:
1. Turn the Printer OFF and unplug it and from the power
source.
2. Release the Separator by loosening the Locking Knob
and moving the Paper Side Guides to their maximum
opened position.
3. Lower the Separators so that they touch the Feed Roller.
4. Remove the screw [A] and the Separator Cover [B]. Then remove the Separator [C] by prying it
out of the Holder.
5. Install a new Separator and replace the Separator Support and screw.