Troubleshooting guide

SECTION 4
MAINTENANCE
45
6. Slide the Latch open on the Service Station
Circuit Board.
7. [1] Plug the Ribbon Connector (blue side up) into
the space under the Latch.
[2] Close the Latch.
8. [1] Slide the Service Station into the Service Station port until it touches the bar. Align with tracks
along sides and Guide on Service Station dock floor.
[2] Look down through the Top Cover to make sure Service Station is aligned with the bar.
IMPORTANT! Service Station must be perfectly aligned with bar to prevent misalignment
and operating problems.