Troubleshooting guide

SECTION 4

MAINTENANCE

Replacing the Service Station

The Service Station (located above the Ink Tank Station) cleans the Printhead Cartridge of excess ink and

debris, keeps the Printhead hydrated and protected when not in use, captures ink used to keep nozzles clear,

and acts as a base to support media during printing. It is designed to provide a long service life. However,

should it need to be cleaned, serviced or replaced, follow these steps to remove it.

1. Open the Front Cover (hinged at

bottom). Open the Top Cover.

Release the two latches and open the

Print Engine Clamshell. The Service

Station will not fully eject with the

Clamshell closed.

2. Open the Printer Toolbox. Click

the “Eject Service Station” button.

Once the Printer pushes the Service

Station out, turn the Printer OFF.

TURN PRINTER POWER OFF.

CAUTION

WHENEVER POWERING DOWN UNIT, ALWAYS:

1. PRESS THE POWER BUTTON ON THE CONTROL PANEL.

2. WAIT FOR THE PRINTER TO STOP PROCESSING.

3. THEN PRESS THE MAIN POWER SWITCH ON THE REAR PANEL.