Troubleshooting guide

SECTION 4
MAINTENANCE
35
6. Click “Continue” on the Confirm
screen, then “Refresh Ink Levels”
on the User Interface screen. The
ink colors fill in as the Ink Tanks
are installed. If the ink colors do
not fill in after a few seconds, click
“Replace Ink Tanks” again and
reinstall the Ink Tank(s).
NOTE: If the Ink Tank is
installed, but the Ink Tank
indicator still does not refresh,
see “Cleaning Ink Tank
Contacts” below.
7. When the Printer stops processing and all the fields in
System Status are black, the Printer is ready for use.
8. Close the Front Cover.
WARNING!
The ink in the Ink Tanks may be harmful
if swallowed. Keep new and used Ink
Tanks out of reach of children. Discard
empty Ink Tanks immediately.
Cleaning Ink Tank Contacts
When reinstalling or replacing Ink Tanks, the Ink Level indicator in the Toolbox may not refresh. This may
be due to a dirty Ink Tank Level Prism and/or QA Chip contacts on that Ink Tank(s). You can clean the
contacts as follows:
1. Remove the Ink Tank(s). Open the
Toolbox. Click “Replace Ink Tanks”.
Once the “Confirm” window opens, it is
safe to remove the Ink Tanks.
IMPORTANT: DO NOT press
“Continue” until after you have
removed and replaced the Ink
Tank(s) and closed the Ink Tank
Latches.