Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

Install/Remove Envelope Attachment Spacers

Install the Envelope Attachment Spacers if you are printing large volumes of envelopes. Remove the

Spacers if you are primarily printing sheet stock. DO NOT use the spacers without the Envelope

Attachment (Head Media Guide).

Install:

1. Insert the right-hand Spacer (smaller)

into the hole in the Service Station

Platen [A].

2. Insert the left-hand Spacer (larger) in

the hole on the left end of the Service

Station Platen [B].

3. Wipe the Printhead Nozzles end to end

using distilled water and a damp lint-

free cloth. Close and latch the

Printhead Clamshell. Close Top Cover.

Remove:

1. Carefully pull out the right-hand

Spacer (smaller) in the hole in the

Service Station Platen [A].

2. Carefully pull out the left-hand Spacer

(larger) in the hole on the left end of

the Service Station Platen [B].

3. Wipe the Printhead Nozzles end to end

using distilled water and a damp lint-

free cloth. Close and latch the

Printhead Clamshell. Close Top Cover.

NOTE: When removing the Head Media

Guide or servicing or replacing the Service

Station, DO NOT discard the 2 Spacers,

remove and save or reuse.