Troubleshooting guide

SECTION 2

INSTALLING THE PRINTER

4. Wet the Printhead Surface. This ensures

that the Printhead will prime correctly.

Open the Top Cover. Release and lift the two

latches at the same time to raise the Print

Engine Clamshell. Moisten the Printhead

nozzles using distilled water and a damp,

lint-free cloth, wiping end to end. (Gray

strip located below orange strip.) Close and

latch the Print Engine Clamshell.

CAUTION

HOLD ONTO BOTH LATCHES

WHEN OPENING AND CLOSING

THE PRINT ENGINE CLAMSHELL

TO PREVENT DAMAGE.

DO NOT ALLOW THE CLAMSHELL

TO DROP OR SLAM CLOSED.

TO PREVENT DAMAGE TO THE INK

LINES, A STOP LIMITS RAISING

THE CLAMSHELL MORE THAN 60°.

5. Close the Printhead Latch [6]. The Printer

will start up and prime ink into the Printhead.

This may take a few minutes. Make sure that

ink is flowing through the hoses.

6. Watch the Toolbox screen. Notice that some of the

information is in red. As the Printer circulates ink

and primes the system these fields should all turn

black.

7. When the Printer stops processing and all the fields

in System Status are black, the Printer is ready for

use. Close the Top Cover.

NOTE: The Printer may take up to 12 minutes to set

itself up during initial startup. This is normal.